Installing a door opener for your garage doesn’t have to difficult—not if you know what you’re doing. If you don’t, then all you need is plenty of research to point you to the right direction. Read on for a few tips to get you started for garage door installation in Chester County:
8
Steps
Step
1: The door opener should be positioned right at the center of the
door. Take the proper measurements to help you pinpoint the exact
spot. A tape measure should be handy in determining the width of the
garage door. Half of the width is the center. On the inside of the
door, up the top, put a short vertical line that goes through the
center of the door. Install the drawbar here.
Step 2:
Determine the highest point of the door. Put the rail above that.
That will prevent the door from hitting the rail whenever you open
it.
Step 3: Find a location right above your garage door to
which you can securely attach the front end of the rail.
Step
4: Attach the rail to the motor unit you have on the garage floor.
Make sure you follow the instructions in the kit. Lift and fasten the
outermost of the rail right to the front mounting plank at exactly
two inches above the intersecting marks you made. Don’t remember
the marks? Review step one! Also, do this step when the garage doors
are down.
Step 5: Put the motor assembly where the rail is
horizontal. Check the door by raising and lowering it. If the height
is right, it’s time to secure the motor assembly to the garage
joists. Make sure you use toggle bolts for heavy-duty purposes when
you secure the mounting hardware to the panel.
Step 6: Put the
carriage to its closed-door position after connecting the drawbar to
the rail carriage. Drill the holes in the door for your drawbar
mounting screws. Mount the drawbar. Go back and tighten the hardware
that holds the drawbar to the door to make sure it’s secure. You
wouldn’t want accidents to happen like falling door opener parts so
don’t leave until you know the entire thing will hold well and
steady.
Step 7: Adjust the drive chain or lead screw,
depending on what your door opener system needs.
Step 8: Put
in the radio receiver.
These easy-to-follow steps effectively walk you through the process, but there are plenty of situations in which you’ll find yourself needing a professional for garage door opener installation in Chester County. Get in touch with Smoker Door Sales to provide the best solutions.
